ATI’s new Damper Hub (Part # 916582H) eliminates the Danny Bee lower pulley and replaces it with a pulley machined into the Damper crank hub to eliminate the ½ inch that must be removed from the hub for spacing. This new hub greatly increases the “press length” from the hub to the crankshaft allowing the Super Damper to do a superior job of removing harmonics. ATI’s new hub targets supercharged motors, has dual keyways and is machined from 4140 heat-treated material. It will fit all Small Block Fords using four bolt pulleys and a four inch long Damper.

6-inch and 7-inch Dampers are also available for this hub with the 7-inch aluminum Super Damper recommended for the high horsepower motors. This Damper is also available with magnets built into the outer shell for a crank trigger application.


Scott Yaffe
Marketing Manager

ATI Performance Products
T: (410) 298-4343
F: (410) 298-3579

Email Us

Back